A fearsome Demonic Dragonborn rises from the ashes, its twisted horns and tattered wings radiating ancient infernal power. With razor-sharp claws and a battle-worn stance, this creature embodies the fury of a forgotten abyss.

Figure is perfect for dnd games, good for paiting and also not problematic with print.

Part of my figures collection:

• Corrupted Dragonborn Miniature
• Winged Champion Miniature
• Talon Banner Guard Miniature
• Gnoll Miniature
• Serpent Warrior Miniature
• Frostguard Miniature
• Dragon Emerald Guardian Miniature

Recommended settings when printing:
(Not counting the shared print profile)

- Cooling at 100%
- Reduce the print speed
- If you have problems with the supports:
    - clean build plate
    - clean build plate, but more precisely

Notes on removing the supports:
! Pay the most attention to the supports around hands and wings, the rest of the supports slowly and gradually, and it will go without problems, supports on base need some time but try to breake them with the help of the legs on the sides. !

Three figure height versions are available:

50mm height, 0.08mm layer,
75mm height, 0.08mm layer,

100mm height, 0.12mm layer,

I hope you enjoy the model I've shared, and that you'll end up with a fantastic miniature or a practical figurine to paint and play with. Thanks you for all likes, downloads, and, above all, prints!