Demon Mug/Beer/Can Holder

🖨 Print Settings for low fillament use.
• PLA or PETG.

• Layer height: 0.2 mm (Standard)

• Seam position: Back

• Infill: 5% Gyroid

• Bottom shell layers: 4-5

• Supports: Tree Supports (Support only critical regions enabled)

Fits long EU cans (beer,energy drink etc) with a capacity of 0.5L

You can print with 10-15% gyroid and Tree Supports (Support only critical regions disabled) for best results

Clean details, optimized for smooth finish and minimal post-processing.

You can find the entire collection in my 3d models.

If you print it, don’t forget to upload your make and follow for the next characters in the collection 💀🔥