MyStrom Button – Wall Mount Holder

Give your MyStrom smart button a permanent home! This clean, minimal wall mount holds the MyStrom Button securely in place – perfect for fixed locations like light switches, door frames, or any wall surface.

The Problem

The MyStrom Button is a great smart home device, but without a dedicated holder it tends to wander around or get misplaced. This mount gives it a fixed, always-accessible spot exactly where you need it.

Features

• Perfect fit – precisely sized for the MyStrom Button
• Open front design – button remains fully accessible and pressable at all times
• Single screw mounting – quick and easy installation on any wall or wooden surface
• Low profile – sits flush against the wall for a clean, integrated look
• Snap-in style – button slides in from the front and is held securely by the rim
• Suitable for indoor and sheltered outdoor use

Print Settings

• Material: PLA or PETG recommended
• Layer height: 0.2 mm
• Walls: 3 perimeters
• Infill: 20–25%

Hardware Needed

• 1× countersunk screw for wall mounting

A simple print that turns your MyStrom Button into a proper smart home switch – right where you need it!