A 6–7 fidget spinner for MEME, satisfaction, and a laugh. It spins smoothly, minimal noise, and fits perfectly in your hand. Bring it around to show people—I GURANTEE you will get a laugh.

This model prints without supports, only cost 17g of filament, and is optimized for a 0.4 mm nozzle.

Assembly Notes:

• Easy assembly using superglue ONLY for the two caps
• DO NOT glue any other parts of the spinner
• You may need to gently crack the middle section so the bearing can move freely
• No actual bearing require

This design has gone through over 6 refined prototypes to achieve the best possible performance:

• Smooth and long spin
• Low noise operation
• Improved durability
• Comfortable, perfect hand fit
• Minimal filament require

Fully designed from scratch in Fusion 360. No AI tools were used—every part was manually engineered, tested, and refined for performance and reliability.