Watto's Chance Cubes

Hey! This is a super fun and quick project for you all to make. The only other similar model costed money and I thought that was un-acceptable considering how simple the file is, so I made my own and am sharing it here.

Print settings:

recommend a very high infill for a premium, weighted feel. 50-100 percent still only takes a few grams of filament, and a slightly longer print

Tutorial:

To get a weathered look, I mixed a bit of gray acrylic paint with a small amount of water. I then poured it over each cube using a sponge to get rid of extra paint and make sure it was spread well.

Once dried, I recommend using a small brush and painting the corners/edges of the cube. I personally used some brown acrylic paint.

Then, Just paint the red/blue squares. I used and old brush from the dollar store and kind of lightly “stabbed/jabbed” the cube to avoid obvious brush stroked and add the the effect.

overall, this is a super quick and fun craft if you don't want to dedicate hours into something

Descrição