This design is for personal use only. If you would like to sell physical prints, please support my work by purchasing a commercial license through a thangs or patreon membership.  Your support is greatly appreciated!

[https://thangs.com/designer/Keppy3d](https://thangs.com/designer/Keppy3d)

[https://www.patreon.com/cw/keppy3d](https://www.patreon.com/cw/keppy3d)

⭐ Included:
Dumpling clicker (All 3 faces included)

💙 Additional parts needed:
This design requires a mechanical keyboard switch. Most MX switches can be used. I am using Gateron switches which can be purchased on amazon.

✨ Filament used:
Bambu Yellow
Bambu Black
Bambu Pink
Bambu Cyan
Bambu Purple

⚙️ Print Settings:
Layer Height: 0.16 mm
Wall Count: 2-3 walls
Infill: 10%-15% Gyroid

🍫 Assembly:
Remove the support from the dumpling.
Place the switch into the square hole in the basket and push down.
Place the dumpling over the switch and push down firmly.