Parametric and stackable organizerbox designed by me. This version is meant for glued in sticks/blocks instead of the usual pressed in ones, with a tight fit however you may not glue. 

In the .3mf you will find 2 boxes as an example, plate 1 is one smaller box and plate 2 needs to be printed twice for a bigger box. I used 8,2x23,2 as block format as mine were 23x8 instead of 22x8 mm.

Carefully measure the actual size of your blocks, they can vary from the advertised sizes!

The length of the box depends on the length of your blocks.

Example: if you have 23x8 mm blocks, its width is 23 mm and heigth is 8 mm 

paramteric guide:

Parametric models use a parameter instead of a fixed value and changing that value of a parameter makes it possible to adjust the model to your needs. For the boxes to remain stackable you have to pick a value for every parameter and from there only change the “sides” parameter to adjust the height. Only side pieces of the same width and thickness will be stackable.

sides: amount of wooden blocks on the sides/ left and right,  I do not recomment smaller than 2

bottom: amount of wooden blocks on the bottom, I do not recomment smaller than 3

space: gap between the wooden blocks,  I do not recomment smaller than 1 mm

bridgeThickness: material surrounding the wooden blocks where supported by nothing else, I do not recomment smaller than 1 mm

sideThickness: thickness of the side piece/front and back,  I do not recomment smaller than 8 mm

widthBlocks: longer side of the end, example = 23 mm, add 0,2-0,4 for easy fit and space for glue

heightBlocks: shorter side of the end, example = 8 mm, add 0,2-0,4 for easy fit and space for glue

I hope you endjoy the model. If you do, a boost would help me.