Had a few requests to upload the Bee version of the Sunflower's pollinators.

Pictures shown are printed in an 0.4mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Orange  Transmission Distance: 7
    PLA BambuLab Basic Sunflower Yellow  Transmission Distance: 8.5
    PLA BambuLab Basic Jade White  Transmission Distance: 4.6
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer (0.88mm) swap to Orange
    At layer (1.12mm) swap to Sunflower Yellow
    At layer (1.36mm) swap to Jade White for the rest.

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away.