A very detailed Carnotaurus skull model made for display printing. The skull is split into a top and bottom piece so it prints easier and both parts connect together using pegs.

The fit should snap together pretty well on most printers without glue, but you can always add a bit of glue if you want it permanent.

Printing tips:

• I recommend slowing the printer down a bit for better surface quality
• Lower speeds also help stop the supports from getting knocked over
• Smaller layer heights will give nicer detail on the skull

The model prints in:

• Top skull piece
• Bottom jaw piece

Hope you enjoy printing it. Feel free to leave a rating or boost if you like the model.

Be sure to check out my other dinosaur models and skulls on my profile if you want to build a full collection.

I’m also open to requests — if there’s a specific dinosaur or a very large display model you’d like to see, feel free to leave a comment and I might make it next.