Post Cap - fully customizable

For customizing please use OpenSCAD. I can not assure that customizing with Makerworld customizer works properly.

// --- MAIN GEOMETRY PARAMETERS ---
xDM  -   Total width of the wooden post (X-axis) in mm
yDM  -   Total depth of the wooden post (Y-axis) in mm
pyramidHeight  -   Vertical height of the sloped pyramid roof section
baseHeight  -   Vertical height of the lower sleeve that slides onto the post
tipDM  -   Outer diameter of the rounded sphere at the absolute top
cr  -   Inner corner radius to match the rounded edges of the post
wallThickness  -   Desired uniform wall thickness for the entire cap

// --- SCREW HOLE CONFIGURATION ---
enableHoles  -   Toggle switch: true = generate screw holes, false = solid walls
screwDiameter  -   Inner clearance diameter for the screw thread/shaft
countersinkDiameter  -   Maximum outer diameter of the screw head
holeZ  -   Vertical position of the holes, measured from the bottom edge
embeddingDepth  -   Extra depth to sink the screw head flat/recessed below the surface