General

Coasters that I thought would make a fun set — a honeycomb design, and an abstract bee!
 

Both designs come in closed-bottom and open-bottom variants. The closed bottom gives you a solid coaster, while the open bottom is lighter and uses less filament. There's also a V2 of the bee with some tweaks.
 

These are quick prints — each one takes around 20-30 minutes depending on your printer and settings.

Printing

Any material works for coasters, but if you're putting hot drinks on them, go with PETG or ABS. PLA is fine for cold drinks. No supports needed.

Print Settings

• Layer height: 0.2mm
• Walls: 3
• Top/bottom: 3+
• Infill: 10%+
• Supports: No
   

Happy printing!

Like what I do? Buy me a coffee or boost this model!