Warp Pipe Can Holder

These can coozies are inspired by the warp pipes in Super Mario Bros for the Nintendo Entertainment System. There's an open top and lidded version, and two versions of the base. The square base probably looks better on a shelf, while the circular version is more comfortable to use.

The 16 and 12 oz cans usually measure about 66mm in diameter. The sleek 12 oz cans are about 57.5mm. I used Terracotta PLA Matte and Mistletoe Green PLA Basic from Bambu Lab.

These coozies print in separate pieces, so you don't need an AMS. I left the tolerances just a little loose to (hopefully) make sure that the pieces can actually fit together for everyone. If you don't keep your filament dry it tends to print a little wider than anticipated. I recommend using a thicker glue like E6000 or equivalent if the fit is loose. If it's a tight fit, you could use PVA glue or gel super glue. Just don't glue the top on for the lidded version, because that would be a game over.

Descrição