Customizable Parametric Hole Plug

Customizable Hole Plug

I made this hole plug after being tired of looking at this hole in the floor of my crawl space. It's simple, with a raised wall that matches the interior diameter of the hole and holds the cover in place. The edges are then extended to provide a flat cover. I have added a small hole in the center for easier removal in tight fits.

Since not all holes are the same size, I made it into a parametric file you can edit for your specific hole size.

Parameters

Interior Diameter	This is measured from the outside edges of the raised wall.
Outer Diameter	This is measured from the outside edge of the raised wall to the outermost edge.
Center Hole Diameter	Straight forward. Use a value of 0.01 to effectively remove the hole.
Raised Wall Height	Straight forward. I find the default value sufficient for holes on the floor. For holes on vertical surfaces, you may need to extend the wall height.
Raised Wall Thickness	I do not recommend changing this unless necessary. This is an offset from the interior diameter. This should remain a negative value to maintain consistency with the interior diameter you measured.

Descrição

Customizable Hole Plug

Parameters