PixelClock Case for 8x32 LED Matrix

This model is a case for a PixelClock using an 8x32 LED matrix and an ESP 32 Dev Board controller. There are two display frame versions included:

• Screw-mounted version
• Glue-on version

The display diffuser / diffuser grid is used from this project and is required:

8x32 LED Matrix Frame with Diffuser Grid

The matching firmware for the PixelClock can be found here:
[https://github.com/mBlinkii/PixelClock](https://github.com/mBlinkii/PixelClock)

Compatible Sizes

ESP with USB-C:

• approx. 28.5 mm x 51.8 mm

ESP with Micro-USB:

• approx. 28 mm x 54.8 mm

LED Matrix:

• approx. 80 mm x 320 mm

Required Screws

ESP mounting:

• 4x M2x4

Cable channel / frame:

• 10x M3x6

ESP box:

• 4x M3x8

Frame version without glue:

• 8x M3x4

Stand:

• 1x M4x8
• 2x M3x15
• 2x M3 nuts

Notes

Part tolerances may vary depending on your printer and filament. If needed, carefully clean or slightly widen the screw holes.

For the display diffuser, please use the MakerWorld project linked above. A well-calibrated printer is recommended so the frame and ESP box fit properly.