So this morning I woke up and decided to try and make myself a Pocket Level. After 5 failed attempts this was the result. A standard #2 pencil fits through the smaller hole for marking points and lines. The longer hole is for carpenters pencils, same function. I do not currently have any carpenter pencils so I researched the sizes of them and went from there. So if you find the hole is too small or big, my apologies. The levels are 10x10x29mm. It contains two  12x1.5mm magnets in the bottom. Both available on Amazon, links below.

I designed this myself, used tinkercad, no AI, and only later realized there are many many other pockets levels people have made on here. I hope you will find mine useful if you decide to print it.

I printed it on a P1S using Matte PLA+, 0.4 nozzle, on standard, with 3 wall loops, and 12% Gyroid.

The levels are tight, that is intentional. Lining them up and pushing the pieces together can be difficult. I used CA glue on the posts and to make sure the magnets stay put.

Thank you for checking out my model.

P.S. I included the un-cut raw STL file for those who would rather cut it and add connectors their own way. If you print the STL file as-is it you will not be able to inset the levels. I highly suggest using the 3MF file or using the Open in Bambu Studio option for those uncomfortable with this.

Bubble Levels: [https://a.co/d/00Bcb0KF](https://a.co/d/00Bcb0KF)

Magnets: [https://a.co/d/04wK3ODt](https://a.co/d/04wK3ODt)