"…its structural perfection is matched only by its hostility.”

Xenodon - Tank 09

Arriving to Ugtopia from distant stars beyond, the Xenodon from UG VR. 

I would recommend sanding or smoothing down rough edges on the joints (especially on the arms) for best performance.

Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days and is reportedly prone to cracking.

Please keep the parts in their current orientations; they might require extra supports, but they are placed for optimal printing of the sockets.

Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.)

Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days and is reportedly prone to cracking.

You might need clippers to remove some of the small support bits, but most of them should separate easily.