Experience the classic of board games in a classic, minimalist design. This chess set stands out for its clean, geometric design, in which each piece has been reduced to its essential symbol.

To make the figures heavier, I increased both the wall loops and the infill.  
If weight is not a factor, you can set the wall loops to 2 and the infill to 7%.

This also applies to my speeds and accelerations. The values are set low to avoid artifacts like ghosting and for a better finish.

If you're printing at higher speeds, enable the “Don't slow down outer walls” option in the filament cooling settings. This prevents uneven shine.

The images shown models created with a layer height of 0.2. I set the value to 0.16 to achieve better results, but feel free to reset it to 0.2 if you prefer.

For the Knight and King support is required.

I strongly recommend to clean the print plate with hot water and dish soap for better layer adhesion.

I also recommend to calibrate your flow ratio and the pressure advance for the best results.