If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please.

Important:

1. You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.
2. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). 
3. What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer.
4. Please ensure your filament flow ratios are properly calibrated to get the best results.
5. You may see a floating regions error. This can be ignored.

Printing Instructions

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm.

Remember to select the correct plate type for your printer.

Filaments Used:
PLA BambuLab Matte Charcoal Black  Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray  Transmission Distance: 2.3

PLA BambuLab Basic Gray  Transmission Distance: 2
PLA BambuLab Tough+ White  Transmission Distance: 6.4
 

Swap Instructions:
Start with Black
At layer #26 (1.24mm) swap to Blue Gray
At layer #32 (1.48mm) swap to Gray
At layer #34 (1.56mm) swap to White for the rest.