This case allows you to use the existing packaging foam internal from the Potensic Atom 2 standard packaging. 

it provides a much better level of care and is obviously more durable than the standard cardboard outer sleeve of the original packaging. 

no fixings are required, everything is printable. for the handle, you just need a snip off of filament to attached the internal hinge. 

because of the filament cutter placement on the P1 series and the exclusion zone it isn't possible to print as standard, however, i did print this on a P1P. i used this filament cutter clip and it worked like a charm 👍 certainly worth giving this a go if you need it - 

[https://makerworld.com/en/models/589249-bed-extender-stopper-blocker-remix-p1-x1-series#profileId-510584](https://makerworld.com/en/models/589249-bed-extender-stopper-blocker-remix-p1-x1-series#profileId-510584) 

The case features a TPU rubber gasket as well as feet and top protection too. 

thanks to Fufazor for creating the initial case, I was able to use this as a base for my drone case.