Ever want to fidget the go? 

Here's your solution!

This model was designed to be different than the other rings. I found they are harder for my larger fingers to use, I can't easily spin them. This one was designed with an extra long lobe piece attached to it, allowing it to be spun much easier with any finger, on the same hand or not!

Better yet, it costs less than 25 cents of filament and takes less than an hour to print!

Printing it is straight forward, PLA or other more stable printing filaments is recommended in order to have a smooth experience. There may be sagging filament from the overhangs, it can be removed easily with tweezers and some heat to melt the excess of. Heat it at your own risk however.