Keep your BILLY where it belongs – on the wall, not on the floor.

This bracket secures the IKEA BILLY cabinet to the wall using the cabinet's existing assembly pins – no drilling into the furniture, no modifications, fully reversible.

The bracket clips onto the exposed half of the pins already present in the BILLY side walls, then screws into the wall behind it.

Two mounting variants included:

• 1-screw – for solid walls (brick, concrete) with a single Dübel
• 2-screw – for drywall/plasterboard, spreading the load across two anchors for better pull-out resistance

Print settings:

• Material: PETG recommended (toughness under sustained load)
• Time: ~60 min
• Weight: ~15–18g
• No supports needed

Installation:

1. Partially insert the cabinet's assembly pins into the BILLY side wall as normal
2. Slide the bracket over the exposed pin ends
3. Mark, drill and plug the wall
4. Screw in – done