Customizable shower drain strainer / hair collector for flush mount drain covers. 

Hit “Customize” and make your own drain protector with this parametric model! 

Parameters: 

• Inside Diameter mm - the diameter of your drain cover in mm.
• Width mm - the width of the strainer around the drain cover, this can be left at default, or can be reduced to fit smaller print beds.
• Height above center mm - is the amount your drain cover is recessed from the surrounding surface. Default is -5mm and means the inside lip sits 5mm below the outer edge of the strainer. This value doesn't need to be measured exactly.

I'd recommend printing this in at least PETG, as some PLAs can soften under the temperatures of a hot shower :)

Enjoy and don't forget to: