Original made by @trumble

Easy-to-adjust tool for adjusting the bed levelling nuts on the Flashforge AD5X.

These are designed to be a very tight fit. If they're loose, try setting your XY hole adjustment to a negative value (Quality tab Precision subheading in Orca-Flashforge). These should not be printed in PLA due to their proximity to the heated bed, especially if your printer is enclosed. I used PETG for my ones.

Simply print them off, and push them so that the top (in print orientation) goes onto the nuts.

Note that due to the tight fit, you will almost certianly end up inadvertently moving the nuts a bit (and thus changing the level of the bed) while installing these. As such, even if you don't plan to make any further adjustments right away, be sure to re-run the automatic bed levelling after installing these.

It is possible to remove them, but again, you will likely end up making inadvertent adjustments while doing so.

If you want to support my work, you can do so by purchasing my paid models: [https://www.printables.com/@Trumble/store](https://www.printables.com/@Trumble/store)

Check out my profile for more printable (free) utilities for your AD5X.