Most of it prints really well. However I have had issues with some parts of the flowy cloths and especially the part at the back. However even without these parts (You can see this in the pictures above) it doesn't effect the look of the model to much. I made this model for my cousin as a birthday present because I couldn't find any of the model on here so hopefully this will help other people have a nice model easily. Hopefully the parts that might fail are not to much of a problem.

It is 15% infill with a layer height of 0.12mm. 

With supports is 55g but after the supports are gone it is around 40g.

All the supports are also going from the base so that the model is damaged as little as possible by them.