A Remix of Mechanism's Steam Controller Dock.

As of May 2nd 2026, ahead of the steam controllers public release

Supposedly the stand is to light to stay in place when you remove the controller from the puck so this is my attempt to mitigate that without increasing the size of the stand.

In order for everyone to have multiple options I have added two 20x35x0.9mm cutouts for use with double sided tape and 4 holes each for magnets with sizes Ø10x2mm, Ø8x2mm and Ø6x2mm.
The overhang for the tape are a bit longer than I would like but they appear fine after the print.

The magnets need a bit of force to push in place and should be put in one by one and pressed hard against a flat and hard surface to sit flush with the bottom.
I got my stuff in a hardware store but I've listed some stuff available through maker's supply that should work