🔧 Adjustable GPU Support (110-205mm) – Lightweight, Strong & Fast to Print

Tired of GPU sag but don’t want a bulky, overengineered bracket?
This threaded, adjustable GPU support is designed to be minimal, lightweight (<50g), and extremely quick to print—without sacrificing strength.

🚀 Key Features

• Fully Adjustable (110mm → 205mm)
  Fine-tune the height with a smooth threaded design for a perfect fit in almost any case.
• Ultra-Lightweight (<50g)
  Uses minimal material while maintaining structural integrity.
• Fast 3D Print
  Optimized geometry for quick prints with minimal material usage.
• 2-Part Simple Design
  Easy to print, assemble, and install—no supports needed.
• Strong & Stable
  Built to handle modern GPUs and reduce sag effectively.

🖨️ Print Recommendations

• Material: PETG recommended (PLA works but may deform over time in warm cases)
• Layer Height: 0.2mm
• Infill: 15–25%
• Walls: 2–3 perimeters
• Supports: Not required (depending on orientation)
• PRINT A SAMPLE FROM BOTH PARTS FIRST TO TEST THE FITMENT, IF TO TIGHT INCREASE OR DECREASE THE SCALE OF THE BODY BY 1%

⚙️ Design Notes

• Threaded mechanism allows precise height adjustment
• Compact footprint fits most PC builds
• Designed to balance strength, speed, and material efficiency

💡 Why this design?

Most GPU supports are either:

• Too bulky
• Not adjustable enough
• Or take forever to print

This design focuses on what actually matters:
✔ Clean look
✔ Fast print time
✔ Reliable support
✔ Easy adjustability

📸 Tip

For best results, place the support under the far end of your GPU (near the front of the case) to counteract sag.

If you like the design, consider leaving a 👍 and sharing your print!