Parametric Coin Display

A clean, customizable display for your favourite coins — works with 
coins from 6 countries out of the box, and you can dial in custom 
dimensions for anything else. Press your coins in from the front, 
pop them out from the back through the push-hole when you want them. 
No glue, no clips, just a snug fit.

Hit the Customize button to set everything up, then print your own Coin Display!

!!! Try a smaller sized coin display first to check if your printer works well with the standard tolerances !!!

!!! If it is too loose or too tight, adjust the tolerances or put in your custon dimensions !!!

🪙 Supported Coins (35+)

- Euro — 1c, 2c, 5c, 10c, 20c, 50c, 1€, 2€
- USA — Penny, Nickel, Dime, Quarter, Half Dollar, Dollar Coin
- UK — 1p, 2p, 5p, 10p, £2 (round coins only)
- Switzerland — 5 / 10 / 20 Rappen, ½ / 1 / 2 / 5 Franken
- Canada — 5¢, 10¢, 25¢, Toonie
- Japan — 1, 5, 10, 50, 100, 500 Yen
- Custom — punch in your own diameter and thickness

⚙️ Customizable

- Grid size: any layout from 1×1 up to 20×20
- Tolerance: tight press-fit or loose, your choice
- Spacing between pockets
- Plate corner radius (0 = sharp, 20 = very rounded)
- Push-hole size (controlled via ring width)
- Pocket entrance chamfer for easy insertion
- Material thickness behind the coin

💡 Tips

- Default tolerance is 0.10 mm. 
- Coin won't go in? Increase tolerance by 0.05 mm. 
 Falls out? Decrease it.
- The chamfer at the pocket edge (default 0.5 mm) makes inserting 
 much easier — set to 0 if you want sharp edges.
- For very small coins (1c, dime), the push-hole shrinks too. 
 Reduce ring_width if you want a finger-friendly hole.

📐 Custom coins?

Pick "--- Use custom Values ---" from the dropdown and enter your 
own diameter and thickness. Tolerance still applies on top.

Enjoy! Boost & follow if you like this Model! 🚀