Hex Bit Holder for Multiboard

A simple holder for 1/4" hex bits that clips onto the Multiboard. Holds 20 bits in two columns of 10.

Why I made it

Other models I found either had an inefficient footprint on the board (especially with long bits) or were too large for a small secondary bit set. By angling the bits out they all remain accessible without taking too much board real estate. The narrow profile fits well on the edge close to the wall or next to other accessories.

Printing notes

• No supports required
• Any standard filament works (PLA is great)

Foot notes

• I always include STEP files to make remixing or just playing around with my models easier. If you see them missing please let me know and I will add them!
• One day, filament recycling will be viable. This is why I always deboss material names on an inconspicuous face of my models and I encourage you to do the same. When you will no longer have a use for the part you print today, if by then recycling made it to or near our homes, you will know for sure what it was printed out of.