Designed for A1 Mini as a custom gift box for many fidget toys available on this marketplace. Outside dimensions are 70 x 70 x 70 mm and the walls are 3 mm thick. The hinges are modeled to be robust and not to take up too much internal space. The latch snaps into the chest body groove to hold the chest closed. To open the chest, press lightly on the front wall

Assembly:

1. Press-fit the latch into the lid.
   1. The latch is designed for good friction fit, but each filament can behave differently. If the fit is too loose, use a drop of glue to hold it in place.
2. Put the lid hinges into the recesses on the top of the main chest body.
3. Push a bit of filament (ideally same color as used for the chest) through the holes in the center of the hinges on both sides of the chest.
   1. Make sure that the filament goes through the entire hinge and the end passes through the hole on the inside of the chest.
   2. Pull the filament so it's flush with the wall on the inside of the chest and cut off the excess with flush cutters.
   3. This part was also designed for good friction fit, but if the filament is too loose, use a drop of glue for it to stay in place permanently.

Version 1 of the model is intended to be printed in 2 separate parts: 1. main chest body and the lid, 2 latch. I recommend printing body and lid with the same color and use a different color for the latch for contrast. The latch orientation is not optimal, but it is like this to highlight the 3d plate effect.

Check also my other models:

• Small Minecraft Chest for A1 Mini

• Small Minecraft Double Chest for A1 Mini

• Medium Minecraft Double Chest for A1 Mini

• Large Minecraft Double Chest for A1 Mini