Project: Charizard.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.4mm and the Actual Thickness is 2.32mm

Filaments Used:
    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.1
    #0086d6 PLA BambuLab Basic Cyan  Transmission Distance: 2.4
    #00ae42 PLA BambuLab Basic BambuLab Green  Transmission Distance: 2.6
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5.8
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 3.7
    #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 5.2
This print uses 6 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Cyan
    At layer #11 (0.96mm) swap to BambuLab Green
    At layer #12 (1.04mm) swap to Jade White
    At layer #13 (1.12mm) swap to Black
    At layer #15 (1.28mm) swap to Red
    At layer #19 (1.6mm) swap to Yellow
    At layer #21 (1.76mm) swap to Red
    At layer #22 (1.84mm) swap to Yellow
    At layer #23 (1.92mm) swap to Jade White for the rest.

For single AMS users, start with 4 colors as follows,
Slot1: Black
Slot2: Cyan
Slot3: Green
Slot4: White
Pause was set at Layer 14 to allow color swap:
Slot2: Cyan --> Red
Slot3: Green --> Yellow