Nintendo Switch 2 Wall Mount

Switch 2 Wall Mount & Game Organizer (Heavy Duty)

I designed this wall mount for the Switch 2 because I wanted something completely solid that wouldn't sag, stretch, or snap over time. It securely holds the console dock and has slots up front for 12 game cartridges.

A few notes on the design:

No sharp internal corners: I added a small circular relief cut where the back wall meets the bottom shelf. Sharp 90-degree angles are usually where 3D prints snap under a heavy load, so this cut spreads the stress out and keeps the bracket super rigid.
Easy fit: The dock itself is 51.5mm wide, so I modeled the shelf at about 53mm. It drops in smoothly without scraping the sides, but still looks flush.
Visible game labels: The cartridge slots are about 10mm deep. They hold the games securely, but leave enough of the cartridge sticking out so you can actually grab them and read the titles.
Mounting: The screw holes are chamfered so standard drywall or wood screws will sit perfectly flush without wedging the plastic apart.

Print Recommendations (The included .3mf has all my settings):

Material: I highly recommend using PETG (I used Overture Black). If you use standard PLA, it will eventually warp and stretch under the constant weight of the console.
Nozzle: I sliced this for a 0.6mm nozzle. It pushes a lot of plastic, saves time, and gives the part a ton of extra strength.
Walls & Infill: I went with 5 wall loops and 15% Gyroid infill. With a 0.6mm nozzle, those 5 walls create a solid 3mm shell that does basically all the heavy lifting. If you switch to a 0.4mm nozzle, just up the number of wall loops to 7 or 8 to get the similar wall thickness. The 15% Gyroid just acts as a clean, strong internal skeleton.

Let me know if you print it or have any questions

Descrição