Adjustable Picture Hanger

Simple wall hanger for canvases. Mounts on a single nail or screw and allows small left/right adjustment for easy centering. Includes a center notch to help position it during installation. Uses less than 6 g of filament.

Recommended Print Settings

Layer height: 0.28 mm
Infill: 100%
No supports needed

Hardware Used

2 self-tapping screws 3 × 15 mm

Installation

Find the center of your canvas/frame.
Use the center notch to align the hanger.
Mark the screw positions.
Pre-drill small holes in the wood frame using a hand pin vise or small drill.
Attach the hanger with two 3 × 15 mm screws.
Place the wall nail into the desired tooth slot.
Slide left or right until perfectly centered.

Notes

Best used with lightweight to medium-weight canvases.
Pre-drilling helps avoid splitting the wood.
For maximum stability, add small rubber pads to the bottom corners of the frame.

Descrição

Recommended Print Settings

Hardware Used

Installation

Notes