SNES Controller Bic Lighter Case. Fits my standard Bic lighter great although lighter sizes my vary. Lighter can be pushed out from bottom hole if too tight to pull out by hand. Lighters with a sticker or graphic wrap might not fit.

There is a pause at 127 to swap out the dark grey for purple to finish.

Do not use supports.

In order to print this on its side without auto supports there are 3 vertical posts that support top while printing and some filament that as it spans the inside top of the lighter slot sags a bit and will have to be removed. The posts can be pulled out quite easy with pliers. I recommend using one side of a pair of scissors to scrape any other loose debris.