Flag holder/ Hook for Walls

I designed this hook model to mount flags on walls.

General

You will normally need two hooks to hang up a flag. To ensure that the plates are completely hidden, print one left hook and one right hook for the corresponding sides.

printing

I used the following print settings:

no supports

no adhesion/ raft

50% Infill (to ensure good holding strength)

make sure to print it in the orientation shown in the picture! (or just use the print profile)

Installing

I used double sided tape to install my hooks. If you want, you can use a file to roughen the surface of the wall plate to ensure that the tape sticks well, as this is the biggest weakpoint.

Also, some flags, like mine, don't have mounting rings on both sides. I just used some scissors and cut a hole into the other side.

1. Apply a piece of double sided tape to the hook and make sure it sticks well. 
2. remove the protective layer and press it firmly against your wall
3. hang up your flag :D

I hope this model helps! If it did, be sure to leave a like and post some pictures in the comments below! 

Happy printing! :D

© 2026 Pallas inc. all rights reserved