Protogen Keychain - AMS IS NOT required, read below!
 

This is a simple protogen keychain design i made in a day based on BossMonsta's design, i highly encourage you check them out as their store is pretty neat  _(:0」∠)_
 

The model measures about 55mm in size but you can scale it up and down to your liking in the slicer. 0.2 nozzle for best quality (not tested but im assuming its the case anyway), but 0.4 will print just fine.
PLA for best quality, you can go for PETG for durability though.


NO AMS/CFS USERS: You have one of two options, one is to add a pause before the details show up and swap the filament, or you could just run to the store and get a marker.. be careful though as some paint may drip down and ruin the look of the print. 

As always, leave a comment below if you'd like to see more stuff or if you have any issues with the model! I'll try my best to fix any issues you may be having.

AI was not used in the creation of this model, I highly encourage creators to do the same since it really isn't that hard to make a model by yourself.