Got some suggestions to also create a ejection effect part for Blaster after we did one for Soundwave, so here we go!

This is the main piece is tape shaped and goes into Blaster's chest. It has a simple shape which can be either printed in a mixed of light and dark grey or painted so that it helps re-create Blaster's on screen look in the '86 movie!

With the tape in place, you can then attach the mount, allowing you to hold up his cassette bots in a mid ejection pose!

And coming over for Steeljaw, we've another custom mount which also pegs into the tape piece in the same way to hold him jumping out!

Now the balance is complete - we can have Blaster face off against Soundwave!

=== Assembly ===

The included diagram shows the three parts which make up this set.

Do note that the SteelJawMount piece comes with a straight peg which can be heated up slightly to be bend into any angle you like for hold him up!

===

So now you you can re-create some more dynamic poses with Blaster and his tape buddies! Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - [https://www.patreon.com/FunbieStudios](https://www.patreon.com/FunbieStudios) | Full listing of Models - [https://funbiestudios.com/model-catalog](https://funbiestudios.com/model-catalog)