This is a robust, space-saving wall mount designed for the Parkside 2-in-1 Mechanic Creeper & Seat. Since many brands use a nearly identical frame design, this bracket will likely fit most similar workshop creepers as well.
The mount consists of two separate hooks that allow you to store your creeper vertically, keeping your workshop floor clear and your walls clean.

New:

- Parametric f3d-File: Adjust the width, length and height of the hook.

Technical Details & Features:
- Dual-Hook System: Simple and effective 2-piece set.
- Mounting: Designed for wall plugs/anchors (Dübel).
- Screw Holes: 5mm core hole with a countersink (fase) for a flush finish.
- Material Efficiency: Both hooks combined use only approx. 60g of filament.

Print Settings (Tested with PETG):
- Walls: 3
- Infill: 18% Gyroid (provides great structural strength)
- Material: PETG recommended
- Supports: No (depending on your print orientation)

⚠️ Important Installation Note:
To prevent cracking or damaging the 3D-printed part, tighten the screws by hand using a screwdriver. Do NOT use an impact driver or high-torque electric drill to tighten the final turns.
 

Support & Feedback

If you find this model useful, please consider leaving a Like or a Rating. I'd love to see your setup-feel free to post a Photo-Comment of your printed hooks in action!

If you have any suggestions for improvements, just let me know in the comments.

Happy printing!