Wall Mount Bracket for Atlas 10" Water Filters

Keep your filtration system organized and secure with this heavy-duty, custom-designed wall mount specifically for Atlas 10-inch filter housings. Whether you are setting up a single stage or a multi-stage system, this bracket provides the stability and clearance needed for easy maintenance.

Key Features

• Perfect Fit: Designed precisely for the Atlas 10" series (standard and BX versions).
• Reinforced Design: Optimized geometry to handle the weight of a water-filled housing without sagging.
• Easy Access: Provides enough offset from the wall to allow for comfortable use of the filter wrench during cartridge changes.
• Print-Ready: No supports required if printed in the recommended orientation.

Recommended Print Settings

• Material: PETG or ASA (recommended for moisture resistance and durability). PLA works but may creep over time under heavy loads.
• Wall Loops: 4–6 (Strength is key here).
• Infill: 25%–40% (Gyroid or Grid).
• Layer Height: 0.2mm or 0.24mm.

Installation

1. Secure the bracket to the wall using heavy-duty anchors.
2. Mount the Atlas filter head to the bracket using the standard mounting screw holes.
3. Ensure your plumbing is supported to reduce additional stress on the 3D-printed part.

Note: Always check for leaks after installation. While 3D-printed parts can be very strong, ensure your print has high layer adhesion to support the weight of the water.

Enjoy your clean water setup! If you like this model, please give it a boost or share your makes!