A fully functional outdoor bird feeder designed from scratch for PETG printing and long-term outdoor exposure. Two open compartments let you fill each side independently; mix seed types to attract different species, or load one side with suet and the other with seed. Your local birds, your call.

Design details:

The body is a two-piece assembly (roof + body) joined with adhesive. No hardware needed — just glue the two halves and you're done. The dividers are a separate slide-in fit. PETG shrinkage has been factored directly into the tolerance, so they should seat snugly without modification or glue. Drainage slots are built into the bottom of each divider channel, so rainwater moves through rather than pooling and spoiling your seed.

Hanging is via string through the integrated mounting point at the top — no hardware required. Footprint is 210 × 210mm, total height approximately 140mm.

This model was designed specifically for PETG and has not been tested in PLA — use PLA at your own risk.

What's included:

• Body (bottom half)
• Roof
• Divider(s)