AMS 2 Pro Stacking Support (v1.0)

Print Time: Approximately 2 hours and 9 minutes x 2 stand.

This is a functional, space-saving stacking solution designed for the AMS 2 Pro. It is a quick-response design to resolve space constraints and speedy printing. While the aesthetic is utility-focused (rough), it provides a reliable vertical mount with one specific trade-off noted below*.

Fitment & Usage

• Alignment: Ensure the front knob seats straight (it is designed to rest in place and does not require locking).
• Refilling*: Please note that the top AMS unit must be lifted slightly to access the filament bays of the lower unit.
• Tested Capacity: Currently verified for a single stacked unit.

Your comments are welcome! Ive downloaded a bunch of prints that have turned in a waste of time/filaments, hopefully this set up works for you.

Disclaimer

This is an early-stage functional design. While the fit is secure on my machine, the tolerances are tight. To prevent surface abrasions or stability issues, monitor the assembly during high-speed printing.

Please use at your own discretion. As with any stacking modification, there is a risk of the unit falling or scratching the plastic lid. My specific print has proven to be secure, but your results may vary based on material and print settings.