Update 

16.06.2026

 - Reinforced the propeller blades, 

 - added a new base,

 - slightly extended the broom handle.

Overview:

Wind spinner inspired by Harry Potter

Instructions:
The full set consists of several parts.

Wizard: hand-painted in the print profile. It uses only two colors, so it’s perfect for H2C or newest X2D. You can also print it in a single color.

Spinner: glue the blades to the spinner and mount it at the end of the broom. A small arrow-shaped pin secures the spinner and should also be glued in place.

Place the wizard onto the broom. It’s a tight fit, so no glue is required. Position it carefully to achieve proper balance. The whole model should stand as shown in the photo.

Base: screw it to a post and insert the broom with the wizard.

If the model is too big for you, you can make it smaller. I printed a 50% reduced version and everything works the same. Only the propeller blades need to be printed on a 0.1mm layer. I also added a print profile with a smaller version.

Have Fun :)