Trying out some new waterfall designs, this is version 3.7, I feel this is the first version that is shareable with everyone, as the past versions had the wrong spacing, or the water movement was not correct.  I used Gorilla Spray Seal for the inside of the base, several layers, as PLA seems to leak over time.

Here is the Amazon link to the pump I used. It comes with the tube that fits as well.

[https://www.amazon.com/dp/B07SKJGNX3?ref=ppx_yo2ov_dt_b_fed_asin_title](https://www.amazon.com/dp/B07SKJGNX3?ref=ppx_yo2ov_dt_b_fed_asin_title)

Here is a link to the fake vines I added to the towers for the garden look.

[https://www.amazon.com/dp/B07JK99MB1?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1](https://www.amazon.com/dp/B07JK99MB1?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1)

Cheers