this is a model i designed after watching the artemis two mission

because i found the mission interesting and so i decided to design this for fun

please note:

the service module (the part with the thrusters)

is printed in two colors so for ease of use i added a profile for AMS users

and a profile that has a pause so that you can change filament manually

assembly instructions:

1.remove the supports from the service module

be very careful when removing the supports around the bigger thrusters

2.glue the command module (the top part)

to the service module (the bottom part)

there is a part n both that correspond so use that as a guide

3.glue the small thrusters into the 24 holes on the service module

I found that they fit ak without gluing so do as you find comfortable 

if the thrusters do not fit in the holes i have a smaller profile that you can try.

4.insert the solar panels into there designated holes 

glue if needed (you probably wont need to).

stand assembly instructions :

insert the long part into the base 

it is a tight fit do no glue is needed but you might need to apply some pressure to get it in

enjoy!!!