The Jar

This is a jar design built for practicality—no complications, no fuss. It’s not trying to reinvent the wheel; it’s just that one container that works perfectly on the first try and is always handy to have around.

What makes it special?

Triple-Start Thread: The lid glides on smoothly and closes fast. No more fighting with the threads to get them to line up.
Great Seal: Despite its simple design, the fit between the lid and the body provides a surprisingly good seal for organizing anything from small hardware to dry food or office supplies.
Print and Go: Designed to print without supports using standard settings. You won't need any special profiles or tedious post-processing.

Sizes Included

I’ve prepared five versions based on height (all of them use the same lid):

60 mm
80 mm
100 mm
150 mm
200 mm

Print Settings

Supports: Not needed.
Material: PLA, PETG, or your preferred filament.
Infill: 10-15% is plenty.
Layer Height: 0.2mm works perfectly to ensure the threads glide smoothly.

Note: If you’re looking for a jar that simply does its job and prints without the drama, this is the one. Hope you find it useful!

Descrição

What makes it special?

Sizes Included

Print Settings