This is a power button light shield designed for Bambu Lab printers (P2S/P1S/X2D/X1/H2), created to effectively eliminate light pollution from the rear power LED at night, making your printing environment quieter and more comfortable.

The base and lid are connected via a hinge and require only a short piece of filament as a pin, with no additional metal parts needed. The flip cover is carefully optimized to hold its position at any angle, allowing for full light blocking or quick access to check the power status—balancing practicality and convenience.

For improved usability, the underside of the lid features a textured anti-slip surface, making it easy to locate and open even in the dark.

🧲 Features:

• 🌙 Blocks power LED light to reduce nighttime light pollution
• 🔧 No additional hardware required
• 📐 Flip lid holds at any angle with smooth, stable motion
• ✋ Anti-slip texture for easy operation in the dark
• 🧩 Form-fitting design that matches the original aesthetic

Ideal for users who are sensitive to ambient light at night or looking to create a more immersive printing environment.

🔧 Installation:

1. Cut a piece of filament approximately 4 cm in length, insert it firmly into the connection hole, and then trim off the excess filament.

2. Disconnect the power connector and insert it into the designated hole on the model.

3. Reconnect the power plug, and the device is ready for use