Mammothor - Tank 02

The large-tusked Mammothor from UG VR.

Please keep the parts in their current orientations; they might require extra supports, but they are placed for optimal printing of the sockets.

Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.)

Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days.

You might need clippers to remove some of the small support bits, but most of them should separate easily.

PSA for tank-class dinos: the feet and leg ball and sockets are rather large. This can cause them to break during assembly if you don't use caution.

This shouldn't occur under normal circumstances, just press them carefully and forcefully together. Tight joints are needed to keep these guys from flopping. Once they're together, they loosen up a bit and form a solid bond.