Update: new profile for colour print without AMS - manual filament change.

Emergency Big Red button - no screws version

Based on some comments I decided to create this version that doesn't require any screws. So, it's fully-fully printable.

Check out other version here: [https://makerworld.com/en/models/2542379-emergency-big-red-button-fully-printable#profileId-2799220](https://makerworld.com/en/models/2542379-emergency-big-red-button-fully-printable#profileId-2799220)

Assembly instructions 

1. Insert three springs into slots - use something pointy (i.e. thin screwdriver, pencil, pen) to fully push the springs into slots - they fit in tight to avoid unwanted falling out
2. Find a mark on the case and align one of the guides on the button to it
3. Push the button into case at angle - aligned guide and marker
4. Fully push the button into the case - some force needed
5. Put together the case - use the dots to align it properly.
6. Have fun :)

Like it? Check out my other designs

Buttons

Fidgets