Project: Hit Monkey.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 133.33x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 1.92mm

    #080a0d PLA PolyLite Black  Transmission Distance: 0.3
    #4c5f71 PLA BambuLab Basic Blue Gray  Transmission Distance: 3
    #ff9016 PLA BambuLab Basic Pumpkin Orange  Transmission Distance: 5.5
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Blue Gray
    At layer #13 (1.12mm) swap to Pumpkin Orange
    At layer #15 (1.28mm) swap to Jade White for the rest.