UPDATE 4/7/26: Rebuilt from the ground up to be less fragile. It still requires some post processing and care during assembly but it's a much easier and more stable build. The center piece of the handle has a small hole at the top to indicate which end goes up. There are two of each handle insert, one each for the top and bottom of the handle. The included sleeve can be printed and used to connect two of these together, just replace the pommel on both sides. I am keeping both versions here just in case you like one over the other. There are subtle differences in the design. Print profile one is the fragile original and print profile 2 is the updated version. Enjoy

Not going to lie, this one is a difficult build. I almost didn't post it. The upper emitter sleeve and the handle sleeves are fragile and take a great deal of care while installing to keep them from breaking. This one also requires more post processing than any of my other models. It was intended as one half of a separatable saber staff but I need to rework the pommel connection so that it will twist and lock. I plan on going back to the drawing board on this one and releasing an updated model at a later date because I really like the way this one looks. I just need to figure out how to simplify it so it's user friendly to everyone. This does not require AMS but it does require some glue. The 3MF has everything separated by color with all of the settings and orientations in place. 

The bronze I used is 3DHojor Silk Bronze