Series II begins.

Metatron arrives as the first of the Greater Heavenly Court — carved in that same calm stone-like aesthetic as the original Archangel series, but elevated, more geometric, more “cosmic order” than the earthly guardians before him.

This one is a little more ornate, and yes… a little more support heavy.
Printed in Bambu yellow PLA he looks incredible, but take your time on support removal. I accidentally clipped part of the wing prototype during cleanup — the geometry sits tight to the robe folds, so patience is key. The halo structure is also more delicate than Series I, so approach that area slowly with snips or heat-release.

He stands slightly taller than the first wave, carrying the Celestial Codex against his chest — the symbol of Metatron as Divine Scribe and Voice of Creation.

Series II explores the higher court: more order, more symmetry, more mythic intention… while still staying fully FDM-friendly and print-safe.

If you’ve started the Council of Angels display stand…
This is who sits at the apex.

📌 Print Notes (important)

• Material:  PLA or any stone-like filament
• Supports: Required (especially behind wings + halo zone)
• Caution:
  • Halo geometry is delicate → remove supports VERY slowly
  • Wings sit close to the robe → avoid aggressive pulling
• Base: Standard 75mm footprint for Series II
• No extreme overhangs — everything remains <45°
• Optimized for single-piece FDM prints